American Gate Entry Systems

Model SWG - Swing Gate Operator

Cabinet

Weather-resistant galvannealed steel cabinet with powder coat finish

Lockable, gasketed, hinged and removable front cover for easy access

Mechanical

Heavy-duty 60:1 right-angle C-face gear reducer

Heavy-duty gate arm assembly with harmonic design for smoother starts and stops

Over-center gate arm "locking" angle

#40 roller chain and sprockets

Adjustable torque limiter

Heavy-duty pillow-block bearings

Mounting

3 - 3 1/2" OD post mounting

Optional pad mounting pedestal available

Anti-Entrapment/Detection Devices:

Operator is pre-wired to accept contact and non-contact detection devices such as contact edges and/or photo electric eyes.

Manual Release

Manual release is easily accessible

Control Circuit

Solid state circuit board, 24 VDC

Inherent current sensing system

15 LEDs for easy setup and troubleshooting

Built in maximum run timer and auto close timer

Right-hand/left-hand easy conversion

Master/Slave - simple three-wire connection

Entrapment Alarm

Warning Signals

Continuous tone entrapment alarm

Warning beeper to sound when gate is moving

Pre-start audio/visual outputs included

Electrical

1/2, 3/4 or 1 HP, 115 or 230 VAC, single phase, thermally protected, heavy duty C-face PSC motor; 1/2, 3/4 or 1 HP, 230 or 460 VAC, 3 phase heavy duty motor

Power on/off switch

Emergency stop/reset button on front cover

Duplex receptacle on 115 VAC units

Three-button control station included

Accessory connections are 24-volt AC or DC

Easily adjustable rotary limit switches

Full system capable for access controls and reversing devices

SL Series Slide Gate Operator Specifications